Taramp's HD8000 1ohm Amplifier Authorized US DistributorAsking $888.00
Shipping OR Local Pickup
Louisville, KY, United States
FREE ShippingCondition:NewItem listed 1353 day(s) ago.Item viewed 197 times.
Sign In to ask question.
Authorized Distributor and Tech Advisor for Taramp's - SPL-Lab USA
We will supply FREE Triple 4/0 adapters for power/ground.
These adapters fit 3 runs each of 1/0-4/0 cable.
13.8 VDC - 1 OHM: 9595W RMS
13.8 VDC - 2 OHMS: 6305W RMS
13.8 VDC - 4 OHMS: 3646W RMS
12.6 VDC - 1 OHM: 8000W RMS
12.6 VDC - 2 OHMS: 5256W RMS
12.6 VDC - 4 OHMS: 3040W RMS
Input Sensitivity: 250mV @ (-9,78 dBm)
Total Harmonic Distortion (THD): 0.5%
Signal / Noise Ratio: >90dB
Damping Factor: 400
Frequency Response: 5Hz to 15kHz
H. P. F (High Pass Filter): 5Hz to 50Hz(-12db/ 8nd ) Variable
L. P. F (Low Pass Filter): 50Hz to 15kHz(-12db/ 8nd ) Variable
Input Impedance: 18k OHMS
Protection: Short on the Output / Supply Voltage High/Low
Minimum Supply Voltage: 10.5VDC
Supply Voltage: 16VDC Maximum
Consumption at Rest: 2.50 Amp.
Maximum Consumption : 412 Amp.
Maximum Consumption in Sinusoidal Signal (1kHz) @ 12.6VDC: 826 Amp.
Dimensions (WxHxD): 9.02" X 2.56" X 19.57"
SPL-Lab USA strongly advises to follow these guidelines to have error-free operation.
- Do not mount amplifier to speaker box. Cyclic Vibrational Failure is #1 fail rate of amplifiers and these are lighter than most so their potential is higher if not followed.
- Do not wire this amplifier lower than 1ohm nominal Impedance. (Equivalent to ~0.7 ohms DCR or Resistive measurement via DMM).
- Do not clip amplifier above 15.0v for extended periods of time
- Do not drive amplifier into clipping + protection for extended periods of time (exceeding 20% THD)
Questions on Taramp's HD8000 1ohm Amplifier Authorized US DistributorNo Questions Submitted.