Taramp's HD6500 2ohm Amplifier Authorized US DistributorAsking $819.00
Shipping OR Local Pickup
Louisville, KY, United States
FREE ShippingCondition:NewItem listed 1508 day(s) ago.Item viewed 223 times.
Sign In to ask question.
Authorized Distributor and Tech Advisor for Taramp's - SPL-Lab USA
We will supply FREE Triple 4/0 adapters for power/ground.
These adapters fit 3 runs each of 1/0-4/0 cable.
13.8 VDC - 2 OHMS: 7796W RMS
13.8 VDC - 4 OHMS: 5129W RMS
13.8 VDC - 8 OHMS: 3079W RMS
12.6 VDC - 2 OHMS: 6500W RMS
12.6 VDC - 4 OHMS: 4277W RMS
12.6 VDC - 8 OHMS: 2567W RMS
Input Sensitivity: 250mV @ (-9,78 dBm)
Total Harmonic Distortion (THD): 0.3%
Signal-to-Noise Ratio: >95dB
Damping Factor: 400
Frequency Response: 5Hz to 15KHz
H. P. F (HIGH PASS FILTER): 5Hz to 50Hz(-12dB/ 8nd ) Variable
L. P. F (LOW PASS FILTER): 50Hz to 15KHz(-12dB/ 8nd ) Variable
Input Impedance: 18K OHMS
System of Protection: Short on the Output Voltage / High power/Low
Minimum Supply Voltage: 10.5VDC
Supply Voltage: 16VDC Maximum
Consumption at Rest: 2.50 Amp.
Maximum Consumption : 351 Amp.
Maximum Consumption in Sinusoidal Signal (1Khz) @ 12.6VDC: 702 Amp.
Dimensions (WxHxD): 9.02" x 2.56" x 18.82"
SPL-Lab USA strongly advises to follow these guidelines to have error-free operation.
- Do not mount amplifier to speaker box. Cyclic Vibrational Failure is #1 fail rate of amplifiers and these are lighter than most so their potential is higher if not followed.
- Do not wire this amplifier lower than 2ohm nominal Impedance. (Equivalent to ~1.4 ohms DCR or Resistive measurement via DMM).
- Do not clip amplifier above 15.0v for extended periods of time
- Do not drive amplifier into clipping + protection for extended periods of time (exceeding 20% THD)
Questions on Taramp's HD6500 2ohm Amplifier Authorized US DistributorNo Questions Submitted.